COMFORT ZONE MEMBERSHIP — Perks & Peace of Mind for just $15.99/mo. Learn More
We're Always Open — Call Us Today!
CALL NOW 24/7

The forced-air furnace is the most common heating system in the Twin Cities, and choosing the right one is about matching efficiency, capacity and budget to your home. As a Trane Comfort Specialist we install the full Trane lineup, and we size every system rather than guessing from square footage alone.

A finished furnace installation — venting, condensate and gas piping done properly the first time.
AFUE stands for Annual Fuel Utilization Efficiency: the percentage of the fuel you buy that becomes usable heat in your home. An 80% furnace sends roughly a fifth of its energy up the flue. A 96% condensing furnace extracts so much heat from the exhaust that it vents through PVC instead of a chimney and produces liquid condensate that needs a drain.
In a climate with our heating season, the fuel savings from stepping up to a condensing furnace are real and usually pay back within the life of the equipment. That said, efficiency is only half the story. A 97% furnace connected to undersized return ducts will still leave your bedrooms cold. We look at the whole system, because the ductwork determines how well any furnace can perform.
A single-stage furnace has one setting: full blast. Two-stage units run at reduced capacity most of the time and only go to high fire when the weather demands it, which means longer, gentler cycles and fewer temperature swings. Variable-speed blowers add fine control over airflow, run quieter, and pair better with air conditioning and humidification. For most Twin Cities homes, a two-stage 96% furnace is the sweet spot between comfort, efficiency and cost.




Drop cloths down, old equipment disconnected and hauled away — no debris left behind.
New furnace set level, gas, venting, condensate and electrical connected to code.
Combustion analyzed, gas pressure set, airflow and temperature rise verified, thermostat configured.

1220 Cope Avenue East, Maplewood, MN 55109

Most furnace changeouts are a one-day, two-technician job.

Venting and piping details are where installs succeed or fail.
CenterPoint Energy and Xcel Energy both offer rebates on qualifying high-efficiency furnaces, and we handle the paperwork rather than handing you a form to mail. Financing is available through Wells Fargo at 0% interest for 18 months on approved credit with a $1,000 minimum purchase.
Free, no-obligation replacement estimates are always available — call us and we will walk your home with you.
In our climate, usually yes. The heating season is long enough that the fuel savings add up, and the higher-efficiency units qualify for utility rebates that narrow the price gap.
Only if the ductwork is the problem's cause and we address it. We measure static pressure and check return sizing during the estimate so we can tell you honestly what a new furnace will and will not solve.
A standard replacement is a single-day job. Converting from an 80% to a 96% unit adds PVC venting and a condensate drain, which we still typically complete the same day.
That comes from a load calculation, not square footage. Oversizing causes short cycling, uneven temperatures and premature wear, so we do the math before quoting.
Fast response — usually within the hour during business hours.
Honest service. No pressure. Emergency? Call (651) 294-7798
Schedule service anywhere in the Minneapolis or St. Paul area today — call us or request an estimate online.
Honest, fair & affordable heating, cooling, plumbing and drain service for the Twin Cities since 2009.
© 2026 Metro Heating & Cooling · 1220 Cope Avenue East, Maplewood, MN 55109 | Website By: Minneapolis Web Design